Installation Guide

2. Secure the Vanity
CAUTION: Risk of property damage. Use care when
moving the vanity to avoid impacting, sliding, or
side-loading the legs.
CAUTION: Risk of property damage. Select 250 lb (113.4
kg) load bearing 5/16″ lag bolts with a length that can safely
clear obstacles in the wall and 5/16″ washers. Calculate the
proper length of the lag bolts by adding the following: 1-1/2″
(38 mm) backing material + wallboard thickness + back rail
thickness.
With assistance, lift and place the vanity in position against the
finished wall. Do not drag the vanity into position.
Verify the vanity is level and the back rail is plumb against the
wall. If necessary, turn the leveler(s) to adjust the unit.
Using a 1/4″ drill bit, drill two pilot holes through the back rail
and the finished wall. Verify the pilot holes are positioned to
ensure the lag bolts will engage the 2x6 backing material.
Secure the vanity to the finished wall with two 5/16″ lag bolts
and washers (not provided).
Pilot Hole
Finished Wall
Leveler
Washer
Lag Bolt
Back Rail
Kohler Co. 5 1207226-2-A