Installation Guide

Tools
Important Information
CAUTION: Risk of property damage. Do not modify the
vanity. Doing so will compromise structural stability and may
cause property damage.
CAUTION: Risk of property damage. Use care when
moving the vanity to avoid impacting, sliding, or
side-loading the legs.
CAUTION: Risk of property damage. Select 250 lb (113.4
kg) load bearing 5/16″ lag bolts with a length to clear
obstacles in the wall and 5/16″ washers. Calculate proper lag
bolt length by adding the following: 1-1/2″ (38 mm) backing
material + wallboard thickness + back rail thickness.
NOTICE: Siliconized acrylic caulk must be used to secure the sink
to the vanity. Do not use 100% silicone sealant which will damage
the finish of the vanity.
NOTICE: The finished wall must be straight and plumb to ensure
proper support of the vanity and alignment of the sink and door.
Observe all local plumbing and building codes.
Provide 2x6 backing material behind the finished wall to properly
support the vanity.
Plus:
• Wood Screws
• 2x6s
• 5/16" Lag Bolts and Washers
[Min 250 lb (113.4 kg) Load Bearing]
• Socket Wrenches
• Siliconized Acrylic Caulk
1207226-2-A 2 Kohler Co.