Operating Guide

3. Secure the Cabinet
WARNING: Risk of property damage. Use care when moving the cabinet to
avoid impacting, sliding, or side-loading the legs.
WARNING: Risk of property damage. The cabinet must be secured to the wall to
reduce the risk of tipping.
Position and Level
With assistance, lift and place the cabinet in the desired location against the
finished wall. Do not slide or side-load the legs.
Verify the cabinet is level and the back rails are plumb against the wall. If
necessary, turn the leveler(s) to adjust the unit.
Verify there is proper clearance around the cabinet for the door to open fully.
Secure
IMPORTANT! If there is no stud present to secure the cabinet to the wall, use 75 lb
(34 kg) load bearing wall anchors. Drill the anchor holes according to the anchor
manufacturer’s recommendation.
Using a 1/4″ drill bit, drill two pilot holes through each side of the back rails and
into the finished wall.
Secure the backside of the cabinet to the wall using four lag bolts and washers.
Sécuriser l’armoire en place
AVERTISSEMENT: Risque d’endommagement du matériel. Procéder avec soin
lors du déplacement du meuble afin d’éviter d’avoir un impact sur les pieds, ou
de faire glisser ou de charger ceux-ci sur le côté.
AVERTISSEMENT: Risque d’endommagement du matériel. Le meuble doit être
sécurisé sur le mur afin de réduire le risque de le faire basculer.
Pilot Hole
Trous-pilotes
Orificio guía
Finished Wall
Mur Fini
Pared acabada
Leveler
Levier
Nivelador
Washer
Rondelle
Arandela
Lag Bolt
Tire-fond
Perno de fijación
Back Rail
Rail arrière
Riel posterior
Kohler Co. 7 1147374-2-D