Full Product Manual

TP-7092 4/23 49
3.7 RDC2 Controller Menus
Controller menus display power system information, including status information for the engine, generator, and optional RBUS
accessories, exercise settings, and event history. Some menus allow changes to the controller settings. Status information,
including the engine runtime, cannot be changed by the operator.
Diagrams in the following sections show how to navigate through the menus. The diagrams show sample settings. Settings for
your application may vary.
Note:
Use caution when navigating the controller menus. In some menus, pressing the Select button can enable editing of the controller
settings. Changing the settings to incorrect values can adversely affect generator set operation or render the unit inoperable.
If a setting on the controller display is flashing, edit mode has been enabled. Press the OFF or AUTO button to exit the edit
mode.
3.8 Main Menu
Press the Select button once to bring up the main menu. Overview is displayed. See Figure 36. Press the down arrow button to
step to the next menu, Engine Metering. Use the UP and DOWN arrow buttons to step up and down through the menus shown
in Figure 36.
The controller will exit the main menu after 5 minutes if no buttons are pressed. To exit the main menu immediately, press the
controller’s OFF or AUTO button.
Figure 36 RDC2 Main Menu
Status
Displays
Press the Up and Down arrow buttons to
move between menus.
Press OFF or AUTO to exit the menus.
Overview --->
1.2 h
Engine --->
Metering
Generator --->
Metering
Genset --->
Information
Genset --->
Run Time
Genset --->
System
Date --->
and Time
Network --->
Information
PIM --->
Status †
Load --->
Control ‡
 ATS Configuration appears only if a Model RXT transfer switch is connected.
†
PIM Status appears only if a programmable interface module is connected.
‡ Load Control appears only if a load management device is connected.
ATS --->
Status
ATS --->
Configuration *
Event Log --->
tp6804