Installation Guide

6. Complete the Installation
Channel
Drip
Loop
Digital
Control
Ports
NOTICE: Do not plug in the pow
er cord until all digital control cables are connected.
IMPORTANT! Make drip loops in all cables and cords.
Route the digital control cable(s) in the wall from the valve location to the digital control installation location(s).
If not already installed, install the digital control(s) according to the instructions packed with the product.
Remove the cover to connect the digital control cable(s) to the valve. Verify that the wires are routed through the wire
channel to prev
ent pinching the wires.
Replace the cover.
Plug the power cord into the valve.
Verify that there is power to the 120 V GFCI electrical outlet.
Plug the power cord into the electrical outlet.
Kohler Co. 13
1430528-2-A