Installation Guide
Symptoms Probable Cause Recommended Action
10. Hot w
ater only, the
valve shuts down.
A. Hot and cold lines are
reversed.
A. Switch hot and cold water supply connections.
Verify that the hot water supply is connected to the
“Hot” inlet and the cold water supply is connected
to the “Cold” inlet.
Compliance
Contains FCC ID: SH6MDBT42Q, Z64-CC3235MOD
This device complies with P
art 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
Changes or modications not expressly approved by the party responsible for compliance could void the user’s authority
to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try
to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiv
er is connected.
• Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Warning
This transmier with its antenna complies with FCC’s RF exposure limits for general population/uncontrolled exposure.
This device must not be co-located or operated in conjunction with any other antenna or transmier. This device should
be operated with a minimum distance of 7-7/8" (200 mm) between the radiator and your body.
Contains IC: 8017A-MDBT42Q, 451I-CC3235MOD
This device contains license-exempt transmier(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference, including interference that may cause undesired
operation of the device.
This transmier with its antenna complies with Industry Canada RF Exposure Limits for General Population/
Uncontrolled Exposure.
This Class B digital apparatus complies with Canadian ICES-003.
Kohler Co. 19
1430528-2-A