Installation Guide

5. Install the Supply Tube
NOTE: Do not remove the plaster guard from the supply tube.
Install a 3/8″ pipe plug into the supply tube, and wrench tighten.
Insert the supply tube through the washer, with the flat portion of
the washer facing the bath interior.
Insert the supply tube through the spout hole.
From underneath, slide the plate (oriented with the tabs up) onto
the supply tube.
Secure the plate with the screws.
Thread the washer and nut onto the supply tube.
Wrench tighten the nut.
Supply
Tube
Plate
Washer
Plaster
Guard
3/8" Pipe Plug
Nut
Washer
1275145-2-A 8 Kohler Co.