Installation Guide

4. Installation on Finished Deck or Rim
NOTE: For installation on a rough (unfinished) deck, proceed to the
″Installation on Rough (Unfinished) Deck″ section.
Tighten the mounting nuts on each valve body from underneath
the deck/rim.
Solder the copper tubes to the valve bodies, tee and spout supply
tube.
Solder the hot and cold water tubes to the valve body inlets (not
shown). Make sure that the cold supply is on the right side.
Go to the ″Check Operation of Valves″ section.
Hot
Supply
Solder
Cold
Supply
Collar
Mounting
Nut
113969-2-AC 8 Kohler Co.