Installation Guide

6. Wall-Mount Support Installation
Install the Anchors
Pivot the metal anchor channel so the plastic straps touch.
Insert the channel into the 1/2″ (13 mm) hole in the finished wall.
Pull on the strap ring until the metal anchor channel is flush on
the inside of the finished wall.
Slide the plastic clip along the straps until it is flush with the
wall.
Break the straps off flush with the finished wall.
Install the Support
Insert the screw through the support flange.
Thread the screw and support flange into the anchor. Securely
hand tighten.
Loosely thread the support bolt completely into the support
flange.
1/2" (13 mm) Hole
Anchor Channel
Ring
Clip
Support Flange
Strap
Anchor
Screw
Support
Bolt
Ring
Kohler Co. 9 1008209-2-H