Installation Guide

12. Multi-Piece Lever Handle Installation
NOTICE: Risk of product damage. Do not overtighten.
Overtightening will damage the handle.
Verify that the valves are in the closed position.
Install the stem extension to the valve stem.
Thread the bonnet onto the valve body.
Align the bath adapter over the stem extension so the holes line
up horizontally. Secure with the screw.
Install the skirt cap to the end of the bath adapter.
Slide the long sleeve, then the O-ring onto the handle arm.
Insert the handle arm through the bath adapter.
Slide the short sleeve, then the washer onto the handle arm.
Thread the end cap onto the end of the handle arm to secure the
assembly.
Repeat for the other handle.
13. Complete the Installation
Open the supplies.
Turn on the hot and cold water.
Run water through both the handshower and the faucet.
Check for leaks.
Bonnet
Screw
Stem
Extension
O-Ring
Bath
Adapter
Short Sleeve
Skirt Cap
Endcap
Washer
Long Sleeve
Handle Arm
OpenOpen
ColdHot
Shown In Closed Position
Kohler Co. 15 1008209-2-H