Installation Guide

7. Complete the Finished Walls
Water-Resistant
Deck Material
5/8" (16 mm) User Interface Hole
Finished Material
Apply 100% silicone sealant.
24" (610 mm)
10" (254 mm)
100% Silicone Sealant
Cover the framing with water-resistant wall material.
Provide suitable access to the control amplier
.
Install the nished w
all and deck materials.
Drill a 5/8" (16 mm) hole through the wall material where the user interface will be installed. Refer to the “Installation
Sequence” section for the recommended location.
Route the user interface cable through the hole in the wall material, and tape or otherwise secure the cable so it will not
fall betw
een the walls.
IMPORTANT! Kohler Co. strongly recommends the use of 100% silicone sealant as instructed. Other sealants with high
ller contents should be avoided, as they may shrink, separate, and peel over time.
Seal the joints between the bath rim and the nished deck with a 1/8" (3 mm) bead of 100% silicone sealant.
Install the faucet trim.
1297608-2-E
14 Kohler Co.