Installation Guide

8. Install the User Interface
Anchors
Horizontal
and Vertical
Adjustment
Hooks
100% Silicone
Sealant
Front ViewBack View
Interface
IMPORTANT! Do not allow the cable routed through the wall hole to fall into the wall.
Push a thin nail into the groove in the back side of the user interface to separate the interface from the mounting plate.
Position the mounting plate over the cable and against the nished wall so the hooks are to the left.
Level the mounting plate and mark the screw hole locations on the wall.
Remove the mounting plate and drill 1/4" holes at the marked locations.
Install the provided wall anchors into the holes.
Apply a bead of 100% silicone sealant to the two grooves on the back of the mounting plate.
Position the mounting plate over the cable with the hooks to the left, and secure to the wall using the two screws
provided.
Check for level. If needed, loosen the screws and adjust the mounting plate.
Connect the cable to the user interface.
Engage the edge of the user interface with the two mounting plate hooks, then rmly swing the user interface against
the mounting plate until they snap together.
Refer to the User Guide included with the user interface to set up, program, and verify proper function of the product.
Kohler Co. 15
1297608-2-E