Installation Guide

1. Prepare the Site
34-1/2" (876 mm)
2x6 Support
Back Rail
CAUTION: Risk of property damage. To properly support the weight of the vanity and vanity top/sink, secure to
stud framing or 2x6 support behind the nished wall.
Install the vanity to two or more studs, with one stud at each end of the back rail. Locate the studs and determine if
additional 2x6 support is needed.
If installing 2x6 support, install 2x6s between the wall studs at the desired vanity location. The height from the nished
oor to the top of the 2x6 support should be 34-1/2" (876 mm) and ush with the front of the wall studs.
Plan for routing supply and drain piping for your desired sink installation.
NOTICE: To verify proper support and alignment: The nished wall must be straight and plumb. The oor must be at
and perpendicular to the nished wall.
Complete the nished wall.
1551656-2-A
4 Kohler Co.