Installation Guide
2. Install the Legs and Shelf
IMPORTANT! Perform this procedure with two people.
NOTE: This vanity is intended to be installed as a oor-mount vanity. The legs must be installed.
Lay the vanity top down on a at, padded surface.
Position the leg assemblies on the boom of the cabinet so that the fastener holes line up.
Loosely aach the rst two legs with the provided hex screws, lock washers, and washers.
Place the shelf in its position, and loosely fasten the bolts, lock washers, washers, and half-circle gaskets into the rst
two legs.
Loosely aach the two remaining legs with the provided hex screws, lock washers, and washers.
Loosely fasten the remaining two sides of the shelf with the remaining two bolts, lock washers, washers, and half-circle
gaskets.
Securely tighten all four legs.
Securely tighten all four shelf bolts.
Carefully stand the vanity upright. Do not slide or side-load the legs.
Kohler Co. 5
1551656-2-A