Installation Guide

Tools and Materials
Tape Measure
Safety Glasses
Saw
Construction Adhsive
Suitable Support Framing Material [3/4″ (1.9 cm) Max Thickness]
Screws
Important Information
IMPORTANT! Before beginning this installation, refer to the
″Roughing-In″ section for cabinet dimensional requirements.
IMPORTANT! This sink must be installed prior to the installation of
the countertop. Cut-line is based from the front face of the cabinet.
IMPORTANT! Long screws may damage adjacent cabinets. Ensure
the screws are long enough to secure the support framing, but short
enough not to extend through the inner walls of the adjacent
cabinets.
Due to the nature of undercounter installations, Kohler Co.
recommends that undercounter sink installations be performed by
trained and experienced installers.
Use proper fasteners and techniques to ensure that the frame will
support a minimum of 300 lbs (136 kg). Locate the fasteners for
easy access in the event the sink needs to be removed.
Plan the sink installation so future removal from underneath the
countertop is possible without damaging the countertop. Do not
use adhesive sealants.
For K-3936 Only: This sink is intended for installation into a
standard 30″ base cabinet.
For K-3943 and K-3945 Only: This sink is intended for
installation into a standard 36″ base cabinet.
For ease of installation, install the strainer assemblies to the sink
prior to installing the sink.
Inspect the drain and supply tubing; replace if necessary.
Anchors and fasteners to be provided and installed by the
countertop manufacturer.
Observe all local plumbing and building codes.
1166709-2-A 2 Kohler Co.