Installation Guide

2. Install the New Toilet
CAUTION: Risk of trap seal loss in back-to-back installations.
To prevent a trap seal loss, back-to-back toilet installations must
be connected to a vertical stack using one of the following three
fittings: double fixture, double combination wye and 1/8 bends,
or double wye and 1/8 bends.
CAUTION: Risk of external leakage. Do not lift or rock the
bowl after placement. If you break the watertight seal, you must
install a new wax seal.
CAUTION: Risk of product damage. Overtightening may cause
breakage or chipping of vitreous china.
Install or relocate the supply and outlet as necessary to conform
to the roughing-in dimensions.
Install a supply shut-off valve.
Record the model number in the Homeowners Guide.
Lay the toilet down onto a padded surface.
From the bottom of the toilet, firmly press a new wax seal around
the toilet outlet.
Remove the temporary rag (if used) from the toilet flange hole.
Align and lower the toilet over the flange and T-bolts.
Apply your full body weight around the toilet to set the seal.
Carefully tighten the nuts.
Bottom of Bowl
Wax Seal
Bolt Cap
Nut
Washer
Bolt Cap Base
T-Bolt
T-Bolt
Closet Flange
1044956-2-B 4 Kohler Co.