Dimensions Guide

Technical Information
Fixture:
Configuration Integral fill and
vertical spray*
Drain hole 1-3/4″ (4.4 cm) D.
Spray hole 3/4″ (1.9 cm) D.
Faucet hole 1-3/8″ (3.5 cm) D.
Diverter hole 1-5/16″ (3.3 cm) D.
Pop-up rod hole 1-1/8″ (2.9 cm) D.
*Requires faucet with transfer valve or diverter.
Included components:
Floor screws and bolt caps 52049
Installation Notes
Install this product according to the installation guide.
Trap can be installed above or below the floor.
Hot and cold supplies can be installed from the floor or the
wall.
For floor supplies, hot and cold must be offset 1″ (2.5 cm)
away from the base (toward the wall).
24-3/8" (61.9 cm)
1-3/8" (3.5 cm)
14-5/8" (37.1 cm)
7-1/2" (19.1 cm)
1-1/4" OD
1-1/8" (2.9 cm)
Spray Hole
5-1/2" (14 cm)
Front of Bidet
*6" (15.2 cm) dimension required to allow for
drain and supply connection from rear of bidet.
*6"
(15.2 cm)
Faucet
Hole
Pop-Up
Rod Hole
Diverter
Hole
9-13/16"
(24.9 cm)
1/2" (1.3 cm) D.
Holes
7-1/2"
(19.1 cm)
15-1/2"
(39.4 cm)
Above
Floor
2"
(5.1 cm)
Below
Floor
1" (2.5 cm)
Offset
Bottom of Rear
Access Opening
2-5/8"
(6.7 cm)
15-1/2"
(39.4 cm)
4-5/8"
(11.7 cm)
2-3/4"
(7 cm)
6-1/2"
(16.5 cm)
10-5/8"
(27 cm)
4-5/8"
(11.7 cm)
17-1/8"
(43.5 cm)
Product Diagram
SAN TROPEZ
®
SAN TROPEZ
®
BIDET
Page2of2
113566-4-
AF