Engine Manual
Table Of Contents
- Safety Precautions and Instructions
- Introduction
- Service Assistance
- Section 1. Components and Maintenance Locations
- Section 2. Operation
- Section 3. Maintenance
- Section 4. Troubleshooting
- Section 5. Storage
- Section 6. Specifications
32 TP-7095 4/18
Change the engine oil and oil filter:
1. Stop the engine and allow it to cool.
2. Place a drop cloth and collection container beneath the oil drain valve. See Figure 13.
Figure 13 Oil Fill and Drain Valve Location
3. Open the oil drain valve and allow the oil to drain into the container.
4. Using an oil filter wrench, remove the old oil filter.
5. Wipe the oil filter installation surface clean with a dry cloth. Inspect the installation surface for damage. See Figure 14.
Figure 14 Oil Filter Installation Location
6. Apply a thin film of fresh oil to the gasket of the new oil filter.
7. Lightly screw in the new oil filter by hand until you feel resistance and then tighten the filter an additional 3/4 turn.
8. Close the oil drain valve.
9. Add fresh oil through the oil filler cap.
10. Check engine oil level, making sure that the level lies between the Full and Add marks on the dipstick. See Figure 15.
11. Install and tighten the oil filler cap.
Oil filter installation
surface
Oil filler cap
Oil drain valve