Engine Manual
Table Of Contents
- Safety Precautions and Instructions
- Introduction
- Service Assistance
- Section 1. Components and Maintenance Locations
- Section 2. Operation
- Section 3. Maintenance
- Section 4. Troubleshooting
- Section 5. Storage
- Section 6. Specifications
40 TP-7095 4/18
Figure 22 Drive Belt Diagram
4. While using the socket wrench to turn the tensioner pulley clockwise, slip the belt around the tensioner pulley. Release
the tensioner.
5. Make sure that the belt is properly aligned with the grooves on each pulley. See Figure 23.
Figure 23 Belt Alignment
3.6.4 Check Wiring and Electrical Connections
CAUTION
Hazardous voltage.
Electrical shock can cause injury.
Do not touch wires while the engine is running. Stop the engine and disconnect the battery
leads, negative (-) lead first, before servicing the engine.
Check the condition of the wiring and electrical connections after every 10 hours of operation. Specific items to look for are:
• Exposed (bare) wires.
• Cuts or abrasions in wire insulation.
• Loose connections at screw terminals.
• Loose, dirty, or cracked electrical connectors.
• Melted or scorched wiring, insulation, or connectors.
Repair or replace faulty electrical components before operating the machine.
Correct
Incorrect
Tensioner pulley
Alternator pulley
Water pump pulley
Crank pulley