Engine Manual
Table Of Contents
- Safety Precautions and Instructions
- Introduction
- Service Assistance
- Section 1. Components and Maintenance Locations
- Section 2. Operation
- Section 3. Maintenance
- Section 4. Troubleshooting
- Section 5. Storage
- Section 6. Specifications
22 TP-7095 4/18
2.2.5 Cold Weather Starting
WARNING
Handling caustic engine fluids and chemical products can cause severe chemical
burns, nausea, fainting, or death.
Most chemicals such as used engine oil, antifreeze/coolant, rustproofing agent, inhibiting
oil, degreasing agent, spray paint, and adhesives are hazardous to health. Read and
follow the user information found on the packaging. Avoid inhalation and skin contact.
Use only in well-ventilated areas and use a protective mask when spraying. Store engine
fluids and chemical products in a locked cabinet. Contact your local recycling center for
disposal information and locations.
WARNING
Explosive fuel can cause fires and severe burns.
If a gaseous odor is detected, ventilate the area and contact an authorized service
technician.
The fuel system. Explosive fuel vapors can cause severe injury or death. Vaporized fuels are highly explosive. Use extreme
care when handling and storing fuels. Store fuels in a well-ventilated area away from spark-producing equipment and out of the
reach of children. Never add fuel to the tank while the engine is running because spilled fuel may ignite on contact with hot parts
or from sparks. Do not smoke or permit flames or sparks to occur near sources of spilled fuel or fuel vapors. Keep the fuel lines
and connections tight and in good condition. Do not replace flexible fuel lines with rigid lines. Use flexible sections to avoid fuel
line breakage caused by vibration. Do not operate the engine in the presence of fuel leaks, fuel accumulation, or sparks. Repair
fuel systems before resuming engine operation.
Cold weather puts added stress on the engine during start up. To start the engine in cold weather:
• Make sure that the engine oil is appropriate for the ambient operating temperature. See the maintenance section for
fluid specifications. Drain and replace the engine oil if necessary.
• Disconnect all applied loads and/or equipment before cranking the starter.
• Allow the engine to run, unloaded, for about 5 minutes after cold weather start up.