Installation Guide

Roughing-In
•
Roughing-in dimensions are identical if using an optional 3″
outlet spud.
•
The urinal complies with ADA requirements when the rim is
mounted no higher than 17″ (432 mm) from the finished floor.
1. Prepare the Site
NOTE: If a pre-existing waste pipe will be used and will result in an
acceptable rim height (refer to the rough-in dimensions), follow the
retrofit installation instructions.
For Retrofit Installations
Turn the water supply line off, remove the existing urinal, then
cap off the water supply line inside the wall.
For New Installations
Install waste pipe as necessary to conform to the roughing-in
dimensions.
Install adequate support framing for the wall hangers as needed.
Floor
Wall
15-5/8" (397 mm)
2" NPT Tap
Spud Detail
6"
(152 mm)
24"
(610 mm)
18"
(457 mm)
2" NPT
Tap
20-3/16"
(513 mm)
Wall Hangers
6-3/4" (171 mm)
16-1/8"
(410 mm) to
Center of
Hanger Slots
29-5/8"
(752 mm)
15" (381 mm)
1/4"
(6 mm)
6"
(152 mm)
14"
(356 mm)
Kohler Co. 3 1048745-2-F