Installation Guide

3. Install the Steam Head(s)
NOTICE: Do not obstruct the steam head with shut-off valves, plugs, or caps.
Subtract 1-1/4″ (32 mm) from the marked length to determine the appropriate nipple size.
Choose a nipple length within 1/8″ (3 mm) of the appropriate nipple size.
Apply thread sealant to one end of the nipple and thread that end into the steam head housing
until hand-tight.
Apply thread sealant to the other end of the nipple.
Position the gasket around the steam head housing so that it will be between the finished wall and
the steam head housing flange.
Usea1″ socket to thread the steam head housing assembly into the elbow in the wall.
Make sure the gasket is compressed and a good seal has been achieved around the edges of the
steam head housing.
Use an appropriate sealant to achieve a watertight seal if needed.
Apply silicone lubricant to the steam head O-rings.
Carefully press the steam head assembly into the steam head housing with the aromatherapy well
positioned on the top of the steam head.
Steam Head Housing
Nipple
Aromatherapy Well
Wall
Lip
Steam Head
Gasket
1/2" Elbow
Lubricate
O-rings.
1230489-2-C 6 Kohler Co.