Installation Guide

5. Operate the Steam Control

Steam Control Operation

NOTE: The clock is always displayed when the steam generator is not in use.

Press the ″Power″ button to start the steam generator.

When the ″Power″ button is pressed the green light on the button turns on. The light remains on

until the unit is turned off. The display reads ″On″ for the ﬁrst 3 minutes of operation if the settings

are not changed.

Press the ″Power″ button again to turn off the steam generator. The green light on the ″Power″

button will turn off and the display will read ″Off″ for 5 seconds, and will then return to display the

clock.

NOTE: When the unit is turned on, the steam duration and temperature settings will be those of the

previous user’s settings. A new steam control unit comes pre-set to operate at 113°F (45°C) for 15 minutes.

Steam Control Operation

NOTE: Make sure the steam control unit is turned on before making any of the following adjustments.

Press the ″Temperature″ button and the display will ﬂash the previous temperature setting. To

adjust the steam room temperature, press the ″Increase″ or ″Decrease″ buttons to raise or lower the

steam room temperature. The maximum allowable temperature is 125°F (52°C), and the minimum

operating temperature is 90°F (32°C).

After 5 seconds, the ﬂashing will stop and the room temperature will be displayed as it changes to

the target temperature.

Press the ″Timer″ button and the display will ﬂash the previous run time setting. Press the

″Increase″ or ″Decrease″ buttons to adjust the time setting higher or lower. After 5 seconds the

ﬂashing will stop and the timer setting will be displayed. If the ″Increase″ or ″Decrease″ buttons are

not pressed the time will continue to count down. The minimum operating time is 10 minutes, and

the maximum time allowed is 20 minutes.

Press the ″Clock″ button and the display will ﬂash the currently set time of day. Press the ″Increase″

or ″Decrease″ buttons to adjust the time of day. After 5 seconds the display will stop ﬂashing and

the set time will be displayed.

Press the ″Power″ button to stop the steam generator and exit the steam room at any time. The

display will read ″Off″ for 5 seconds and then default to the set clock time.

Change the temperature reading between Fahrenheit and Celsius by pressing and holding the

″Temperature″ button for 3 seconds.

Power Clean Function

Clock

Timer

Display

Temperature

Increase

Decrease

Power

1230489-2-C 8 Kohler Co.