Installation Guide

3. Install the Interface
Secure the O-ring to the back of the user interface.
Apply grease (provided) into both ends of the coupler.
Connect the cable from the wall and the interface into the coupler.
Ensure that the cables fully click into the coupler.
Feed the cable and coupler into the hole in the wall. Ensure that a
drip loop is made.
Hook the top of the interface onto the mounting bracket, then
press the bottom until it clicks in place.
Connect
the cables.
Coupler
Press to
click in place.
Hook onto
the bracket.
Apply grease
in both ends.
1143086-2-G 6 Kohler Co.