Product Manual

TP-6810 11/13 51Section 4 Scheduled Maintenance
4.5 Exhaust System
Carbon monoxide.
Can cause severe nausea,
fainting, or death.
The exhaust system must be
leakproof and routinely inspected.
WARNING
Carbon monoxide detectors. Carbon monoxide can
cause severe nausea, fainting, or death. Install carbon
monoxide detectors on each level of the building. Locate the
detectors to adequately warn the building’s occupants of the
presence of carbon monoxide. Keep the detectors operational
at all times. Periodically test and replace the carbon monoxide
detectors according to the manufacturer’s instructions.
At the interval specified in the service schedule, inspect
the exhaust system components (exhaust manifold,
exhaust outlet, exhaust line, exhaust clamps, and
muffler) for cracks, leaks, and corrosion.
Exhaust System Inspection Points
D Check for corroded or broken metal parts and replace
them as needed.
D Check that the exhaust outlet is unobstructed.
D Check the exhaust gas color. If the exhaust is blue o r
black, contact your local authorized Kohler distributor/
dealer.
D Visually inspect for exhaust leaks (blowby). Check
for carbon or soot residue on exhaust components.
Carbon and soot residue indicates an exhaust leak.
Seal leaks as needed.
D Check that all covers and doors are undamaged, in
place, and locked.
D Check for the installation and operation of carbon
monoxide (CO) detectors on each level of any
building near the generator set.
4.6 Cooling System
Hot coolant and steam.
Can cause severe injury or death.
Before removing the pressure cap,
stop the generator set and allow it to
cool. Then loosen the pressure cap
to relieve pressure.
WARNING
Allow the engine to cool. Release pressure from the
cooling system before removing the pressure cap. To
release pressure, cover the pressure cap with a thick
cloth and then slowly turn the cap counterclockwise to
the first stop. Remove the cap after pressure has been
completely released and the engine has cooled. Check
the coolant level at the tank if the generator set has a
coolant recovery tank.
Note: Block heater damage. The block heater will fail
if the energized heater element is not immersed
in coolant. Fill the cooling system before turning
on the block heater. Run the engine until it is
warm and refill the radiator to purge the air from
the system before energizing the block heater.
4.6.1 Checking and Filling Coolant
Maintain the coolant level in the coolant overflow bottle
between the High and Low markings. See Section 1,
Service Views, for the coolant overflow bottle location.
Note: Periodically check the coolant level by removing
the radiator’s pressure cap. Do not rely solely on
the level in the coolant overflow bottle.
Ethylene glycol-based long-life coolant is
recommended. Use a coolant mixture of 50% long-life
coolant and 50% clean, softened water to inhibit
rust/corrosion and prevent freezing. Add fresh coolant
until the level is just below the overflow tube opening.
A coolant solution of 50% ethylene glycol-based coolant
provides freezing protection to --37C(--34F) and
overheating protection to 129C (265F). A coolant
solution with less than 50% ethylene glycol may not
provide adequate freezing and overheating protection.
A coolant solution with more than 50% ethylene glycol
can cause engine or component damage. Do not mix
long-life coolant and conventional coolants. Do not use
alcohol or methanol antifreeze or mix them with the
specified coolant.