Installation Guide

4. Install the Lever Handles
Remove and discard the plaster guards from each valve stem.
Slip an escutcheon and sleeve over each valve stem and against
the finished wall.
Install a spline adapter onto each valve stem.
Install a stem extension onto each spline adapter so the handle
holes are facing each side.
Install the stem extension to each valve stem with a screw
(provided).
Slip a bonnet over each stem extension and thread onto each
valve until the escutcheon, sleeve, and bonnet are snug against
the finished wall.
Slip a center cap onto each bonnet so the two side holes on each
cap align with the two holes on each bonnet.
The lever handles are shipped fully assembled. Remove the end
cap, plastic washer, and short sleeve from each handle.
Slip a lever handle through the two holes on each center cap.
Reinstall each short sleeve so the curved end fits snugly onto the
lever handle arm.
Reinstall a plastic washer and tighten an end cap onto the
threaded end of each lever handle.
Valve Stem
Escutcheon
Sleeve
Spline Adapter
Bonnet
End Cap
Center Cap
Handle Arm
Washer
Screw
Short
Sleeve
Stem Extension
117124-2-A 6 Kohler Co.