Product Manual
Table Of Contents
- Safety Precautions and Instructions
- Introduction
- Service Assistance
- Section 1. Descriptions and Service Views
- Section 2. Generator Set Operation
- Section 3. VSC Controller Operation
- 3.1 VSC Generator Set Controller
- 3.2 Control and Indicators
- 3.3 Controller Power
- 3.4 Battery Charging
- 3.5 Changing Settings
- 3.6 Setting the Exerciser
- 3.7 VSC Controller Menus
- 3.8 Main Menu
- 3.9 Overview Menu
- 3.10 Engine Metering Menu
- 3.11 Generator Metering Menu
- 3.12 Generator Set Information Menu
- 3.13 Genset Run Time Menu
- 3.14 Genset System Menu
- 3.15 Date and Time Menu
- 3.16 Networking Information Menus
- 3.17 Programmable Interface Module (PIM) Status Menu
- 3.18 Event Log
- Section 4. Scheduled Maintenance
- Section 5. Troubleshooting
- Appendix A. Abbreviations
TP-6843 12/21 37
3.11 Generator Metering Menu
The generator metering menu displays the generator voltage and % load. See the figure titled: Generator Metering Menu.
3.11.1 Calibration
DANGER
Hazardous voltage.
Will cause severe injury or death.
Disconnect all power sources before opening the enclosure.
The calibration mode can be entered from the Generator Metering menu. Contact a Kohler-authorized distributor/dealer for
service.
The Reset Calibration menu allows you to set the readings back to the default settings after calibration, if necessary.
See Figure 22.
Figure 22 Generator Metering Menu
Generator -->
Metering
Volts:
54.0V
Load:
73%
Reset
Calibration
Reset
Calib? No
Reset
Calib? Yes
Calibration
Reset
<--- Return