Product Manual
Table Of Contents
- Safety Precautions and Instructions
- Introduction
- Service Assistance
- Section 1. Descriptions and Service Views
- Section 2. Generator Set Operation
- Section 3. VSC Controller Operation
- 3.1 VSC Generator Set Controller
- 3.2 Control and Indicators
- 3.3 Controller Power
- 3.4 Battery Charging
- 3.5 Changing Settings
- 3.6 Setting the Exerciser
- 3.7 VSC Controller Menus
- 3.8 Main Menu
- 3.9 Overview Menu
- 3.10 Engine Metering Menu
- 3.11 Generator Metering Menu
- 3.12 Generator Set Information Menu
- 3.13 Genset Run Time Menu
- 3.14 Genset System Menu
- 3.15 Date and Time Menu
- 3.16 Networking Information Menus
- 3.17 Programmable Interface Module (PIM) Status Menu
- 3.18 Event Log
- Section 4. Scheduled Maintenance
- Section 5. Troubleshooting
- Appendix A. Abbreviations
44 TP-6843 12/21
Figure 30 Procedure to Set the Exerciser on the VSC Controller
Genset -->
System
System Voltage:
54.0V
Auto Start Volt: (V)
Auto Stop Load:
(%)
Load Limit: (%)
Fuel Type:
Natual Gas
Next Exercise *
HR:MN PM MM/DD/YY
HOLD:
Next Exercise
HR:MN PM MM/DD/YY
HOLD:
HOLD:
Exercise Mode:
Loaded
Exercise Mode:
Loaded Full Sp
Unloaded Cycle
Loaded Full Sp
Exercise Freq:
Weekly
Language:
English
Contrast: 50
<-- Return
Exercise Freq:
Weekly/Bi-Weekly
* If the exerciser has not been set, No Exercise Sch will be displayed.