Product Manual

TP-6843 12/21 33
3.6 Setting the Exerciser
Set the exerciser to automatically run the generator set for 20 minutes every week or every two weeks.
3.6.1 Setting the Exerciser at Controller Power-up
When battery power is connected to the controller, you will be prompted to set the date and time, and then to set the exerciser.
The first setting will flash. Press the Up and Down arrow buttons to change the setting. Press Select to save the setting and
move on to the next. See the Changing Settings section for more detailed instructions to change settings on the VSC.
If the battery is disconnected and reconnected during generator set maintenance or service, the time, date, and exercise settings
will need to be re-entered.
3.6.2 Changing the Exercise Settings
See the Genset System Menu, Setting the Exerciser section for instructions to change the exercise settings.
3.7 VSC Controller Menus
Controller menus display power system information, including status information for the engine, generator, and optional RBUS
accessories, exercise settings, and event history. Some menus allow changes to the controller settings.
Diagrams in the following sections show how to navigate through the menus.
Note:
Use caution when navigating the controller menus. In some menus, pressing the Select button can enable editing of the controller
settings. Changing the settings to incorrect values can adversely affect generator set operation or render the unit inoperable.
If a setting on the controller display is flashing, edit mode has been enabled. Press the OFF or AUTO button to exit the edit
mode.