Product Manual
Table Of Contents
- Safety Precautions and Instructions
- Introduction
- Service Assistance
- Section 1. Descriptions and Service Views
- Section 2. Generator Set Operation
- Section 3. VSC Controller Operation
- 3.1 VSC Generator Set Controller
- 3.2 Control and Indicators
- 3.3 Controller Power
- 3.4 Battery Charging
- 3.5 Changing Settings
- 3.6 Setting the Exerciser
- 3.7 VSC Controller Menus
- 3.8 Main Menu
- 3.9 Overview Menu
- 3.10 Engine Metering Menu
- 3.11 Generator Metering Menu
- 3.12 Generator Set Information Menu
- 3.13 Genset Run Time Menu
- 3.14 Genset System Menu
- 3.15 Date and Time Menu
- 3.16 Networking Information Menus
- 3.17 Programmable Interface Module (PIM) Status Menu
- 3.18 Event Log
- Section 4. Scheduled Maintenance
- Section 5. Troubleshooting
- Appendix A. Abbreviations
34 TP-6843 12/21
3.8 Main Menu
Press the Select button once to bring up the main menu. Overview is displayed. See Figure 19. Press the down arrow button to
step to the next menu, Engine Metering. Use the UP and DOWN arrow buttons to step up and down through the menus shown
in Figure 19.
The controller will exit the main menu after 5 minutes if no buttons are pressed. To exit the main menu immediately, press the
controller’s OFF or AUTO button.
Figure 19 VSC Main Menu
Status
Displays
Press the Up and Down arrow buttons to
move between menus.
Press OFF or AUTO to exit the menus.
Overview --->
1.2 h
Engine --->
Metering
Generator --->
Metering
Genset --->
Information
Genset --->
Run Time
Genset --->
System
Date --->
and Time
Network --->
Information
PIM --->
Status
Event Log --->