Product Manual
Table Of Contents
- Safety Precautions and Instructions
- Introduction
- Service Assistance
- Section 1. Descriptions and Service Views
- Section 2. Generator Set Operation
- Section 3. VSC Controller Operation
- 3.1 VSC Generator Set Controller
- 3.2 Control and Indicators
- 3.3 Controller Power
- 3.4 Battery Charging
- 3.5 Changing Settings
- 3.6 Setting the Exerciser
- 3.7 VSC Controller Menus
- 3.8 Main Menu
- 3.9 Overview Menu
- 3.10 Engine Metering Menu
- 3.11 Generator Metering Menu
- 3.12 Generator Set Information Menu
- 3.13 Genset Run Time Menu
- 3.14 Genset System Menu
- 3.15 Date and Time Menu
- 3.16 Networking Information Menus
- 3.17 Programmable Interface Module (PIM) Status Menu
- 3.18 Event Log
- Section 4. Scheduled Maintenance
- Section 5. Troubleshooting
- Appendix A. Abbreviations
38 TP-6843 12/21
3.12 Generator Set Information Menu
The generator set model number and serial numbers are displayed (see Figure 23). No changes are allowed from this menu.
Model and serial numbers are factory-set and should not require changes in the field, except in the event that the controller is
being replaced. A personal computer running Kohler
®
SiteTech™ software is required to enter the generator set model number
and serial numbers on a replacement controller. Contact an authorized Kohler distributor/dealer for service.
Figure 23 Generator Set Information Menu
Genset ---->
Information
<---- Return
Genset M/N:
6VSG-48V
Genset S/N:
########
Controller S/N:
########