Product Manual
Table Of Contents
- Safety Precautions and Instructions
- Introduction
- Service Assistance
- Section 1. Descriptions and Service Views
- Section 2. Generator Set Operation
- Section 3. VSC Controller Operation
- 3.1 VSC Generator Set Controller
- 3.2 Control and Indicators
- 3.3 Controller Power
- 3.4 Battery Charging
- 3.5 Changing Settings
- 3.6 Setting the Exerciser
- 3.7 VSC Controller Menus
- 3.8 Main Menu
- 3.9 Overview Menu
- 3.10 Engine Metering Menu
- 3.11 Generator Metering Menu
- 3.12 Generator Set Information Menu
- 3.13 Genset Run Time Menu
- 3.14 Genset System Menu
- 3.15 Date and Time Menu
- 3.16 Networking Information Menus
- 3.17 Programmable Interface Module (PIM) Status Menu
- 3.18 Event Log
- Section 4. Scheduled Maintenance
- Section 5. Troubleshooting
- Appendix A. Abbreviations
TP-6843 12/21 47
3.16.1 Networking Status Submenu
The Networking Status submenu contains settings for OnCue
®
Plus. See Figure 33. See the OnCue
®
Plus Software Operation
Manual for information about the appropriate network settings. Changes to these settings are not typically required.
If DHCP is enabled, IP parameters are not displayed. If DHCP is disabled (i.e., if a static IP address is used), the IP parameters
are displayed.
To enable or disable DHCP and change the IP settings, go to the Networking Configuration menu. See the Networking
Configuration Submenu (OnCue
®
Password) section.
Figure 33 Network Status Submenu
Networking- -->
Information
Networking- -->
Status
OnCue Status:
Connected
IP Address:
123.456.789.123
DHCP:
Enabled
Subnet Mask:
123.456.789.123
Gateway:
123.456.789.123
DNS 1:
123.456.789.123
DNS 2:
123.456.789.123
Ethernet Status:
Disconnected
OnCue Server:
123.456.789.123
<--- Return