Product Manual
Table Of Contents
- Safety Precautions and Instructions
- Introduction
- Service Assistance
- Section 1. Descriptions and Service Views
- Section 2. Generator Set Operation
- Section 3. VSC Controller Operation
- 3.1 VSC Generator Set Controller
- 3.2 Control and Indicators
- 3.3 Controller Power
- 3.4 Battery Charging
- 3.5 Changing Settings
- 3.6 Setting the Exerciser
- 3.7 VSC Controller Menus
- 3.8 Main Menu
- 3.9 Overview Menu
- 3.10 Engine Metering Menu
- 3.11 Generator Metering Menu
- 3.12 Generator Set Information Menu
- 3.13 Genset Run Time Menu
- 3.14 Genset System Menu
- 3.15 Date and Time Menu
- 3.16 Networking Information Menus
- 3.17 Programmable Interface Module (PIM) Status Menu
- 3.18 Event Log
- Section 4. Scheduled Maintenance
- Section 5. Troubleshooting
- Appendix A. Abbreviations
TP-6843 12/21 17
Programmable exerciser can be set to start automatically on any future day and time, and run every week or every two
weeks
Three exercise modes
Front-access mini USB connector for SiteTech™ connection
Integral Ethernet connector for Kohler® OnCue
®
Plus
Built-in 2.5 amp battery charger
Remote two-wire start/stop capability
Diagnostic messages
o Displays diagnostic messages for the engine, generator, and programmable interface module (PIM)
o Over 70 diagnostic messages can be displayed
Maintenance reminders
System settings
o System voltage and percent load
o Voltage adjustment
o Measurement system, English or metric
Programmable Interface Module (PIM) status displays
o Input status (active/inactive)
o Output status (active/inactive)