Product Manual
Table Of Contents
- Safety Precautions and Instructions
- Introduction
- Service Assistance
- Section 1. Descriptions and Service Views
- Section 2. Generator Set Operation
- Section 3. VSC Controller Operation
- 3.1 VSC Generator Set Controller
- 3.2 Control and Indicators
- 3.3 Controller Power
- 3.4 Battery Charging
- 3.5 Changing Settings
- 3.6 Setting the Exerciser
- 3.7 VSC Controller Menus
- 3.8 Main Menu
- 3.9 Overview Menu
- 3.10 Engine Metering Menu
- 3.11 Generator Metering Menu
- 3.12 Generator Set Information Menu
- 3.13 Genset Run Time Menu
- 3.14 Genset System Menu
- 3.15 Date and Time Menu
- 3.16 Networking Information Menus
- 3.17 Programmable Interface Module (PIM) Status Menu
- 3.18 Event Log
- Section 4. Scheduled Maintenance
- Section 5. Troubleshooting
- Appendix A. Abbreviations
50 TP-6843 12/21
3.16.4 Remote Devices Submenu
Check the status of remote devices communicating through RBUS (see Figure 36). Device types can include:
Programmable Interface Module (PIM)
The serial numbers for the PIM are printed on the circuit boards inside the enclosures.
Figure 36 Remote Devices Submenu
From the figure titled: VSC
Information Submenu
Remote --->
Devices
Connected: Displays the date and time that the device was connected.
Disconnected: Displays the last date and time of successful
communication.
S/N: XXXXXXXXX
<<*DeviceType*>>
S/N: XXXXXXXXX
<<*DeviceType*>>
<---- Return
Module Status:
Connected
Comm. Errors:
12345
Comm. Timeouts:
12345
Module ID:
12
Firmware Ver.:
122
(Dis)Connected:
MM/DD/YY 12:12 PM
Return --->