How to Guide

Product Information
Applicable products:
Bath whirlpool K-702-N1
Bath whirlpool with neckjets and pillow K-702-H2
Fixture*:
Bathing well:
Basin area, bottom 44″ (1118mm)x28″ (711 mm)
Basin area, top 60″ (1524 mm) x 32″ (813 mm)
Weight 555 lbs (251.7 kg)
To overflow:
Water depth 15″ (318 mm)
Capacity 82 gal (310.4 L)
* Approximate measurements for comparison only.
Product kW V A*
Neckjets 1.5 240 15
Without neckjets 1.5 240 11
* Approximate measurements for comparison only.
Drop-in
cut-out
70-1/2″ (1791 mm) x 40-1/2″ (1029 mm)
Included component:
Cut-out template 106594-7
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual
Current Device (RCD):
Pump/control 208-240 V, 20 A, 50/60 Hz
Installation Notes
NOTE: Pump protrusion beyond rim.
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of
61 lbs/square foot (294 kg/square meter) loading.
Hot water supply should be 70% of capacity or greater.
Installations will vary.
Cast iron whirlpools are extremely heavy, making some
drop-in installations difficult. Splitting the deck/surround is
recommended if installing into a deck.
Fixture conforms to ASME A112.19.1/CSA B45.2. All
dimensions are nominal.
K-702-N1
1-1/2" OD
72" (1829 mm)
4" (102 mm)
4"
(102 mm)
36" (914 mm)
42" (1067 mm)
3-3/4"
(95 mm)
3"
(76 mm)
3" (76 mm)
24"
(610 mm)
2-3/8" (6 mm)
10-3/4"
(273 mm)
1-1/8"
(29 mm)
18-1/4"
(464 mm)
13-1/4"
(337 mm)
2-1/2" (64 mm)
Pump Protrusion Beyond Rim
Note:
No change in measurements if connected with drain
illustrated. (K-7158 or K-7158M)
Pump/Control Access
34" (864 mm) W x
15" (381 mm) H
Roughing-In
K-702-H2,K-702-N1
VINTAGE
®
BATH WHIRLPOOL
VINTAGE
®
BATH WHIRLPOOL
1019474-1-
E