Installation Guide

6. Adjust the Operating Glass Panel
The operating glass panel can be horizontally adjusted up to 3″ (7.6 cm) to fit the shower opening.
To Adjust Panel
Using the 5/32″ hex key provided, loosen the screws located in both the top and bottom hinges.
Adjust the panel position by carefully sliding the panel back and forth - position approximately 1″
(2.5 cm) from the strike jamb side of wall.
NOTE: Allow room for the strike jamb installation (refer to ″Install the Strike Jamb and Strike Jamb Cap″
section).
5/32" Hex Key
Screws
Hinge
Adjust glass panel position by sliding back
and forth – position approximately 1" (2.5 cm)
from strike jamb side of wall.
Kohler Co. 9 1011451-2-F