Installation Guide

7. Install the Hanging Brackets — Inside Panel
CAUTION: Risk of injury or product damage. Unframed tempered glass should
not contact hard surfaces or it may shatter. Do not touch the edge of the tempered
glass panel with tools or any hard objects. Do not set unframed tempered glass
directly on the floor.
Insert a bushing into one of the holes at the top of the inside glass panel.
Install a hanging bracket over the glass panel, aligning the hole in the bracket
with the bushing.
Insert a blind nut into the hanging bracket hole and bushing. Secure with a #8-32
x 1/4″ machine screw.
Repeat the steps to install the other bracket on the inside panel.
IMPORTANT! The steel side of the roller must be installed against the hanging
brackets.
The inside panel is installed on the showerhead side of the bath or shower.
Install the rollers on the same side as the bottom frame holes.
Assemble the rollers and #8-32 x 3/8″ machine screws to the hanging brackets
through the center hole of the bracket.
Secure the rollers.
Bushing/Manchon/Buje
Hanging Bracket
Support d' accrochage
Soporte de suspensión
Rollers on same side as bottom frame hole.
Placer les rouleaux du même côté que
l'orifice du cadre inférieur.
Las ruedas deben estar en el mismo lado
que el orificio del marco inferior.
Roller/Rouleau/Rueda
Blind Nut
Écrou borgne
Tuerca ciega
8-32 x 3/8" Machine Screw
Vis mécanique 8-32 x 3/8"
Tornillo para metal 8-32 x 3/8"
8-32 x 1/4" Bolt
Boulon 8-32 x 1/4"
Perno 8-32 x 1/4"
Install inside panel roller.
Installer le rouleau du panneau intérieur.
Instale la rueda del panel interior.
Kohler Co. 17 1063221-2-B