Installation Instructions
14. Install the Fixed Panel
1/4-20 x 3/4"
Install a socket head screw (provided) into the holes in the back wall of the header.
Place a gasket onto each of the screws protruding from the front wall of the header.
Apply a bead of 100% silicone sealant into the boom of the threshold seal.
Remove the adhesive backing from the xed panel wall seal.
Place the xed panel into the channel in the threshold and lean the top of the panel against the header.
Place a gasket onto each of the screws protruding from the holes in the xed panel.
Thread a nut onto each of the screws.
Tighten the screw from inside the header with a 3/16" hex wrench.
IMPORTANT! The head of the screws must be ush with the inside wall of the header when tightened or they will
interfere with door operation.
Press the wall seal tight against the wall if there is a gap.
Install the towel bar to the xed panel using the separate instructions provided.
1460483-2-B
18 Kohler Co.