Installation Instructions

Symptoms Probable Cause Recommended Action
5. Water leaks. A. Water leaks under the
threshold.
B. Water leaks under a door
panel.
C. Water leaks under a door
panel.
D. Water leaks around the
wall seal.
E. Water leaks around the
wall seal.
F. Water leaks at the boom
of the wall seal and over
the threshold.
G. Water leaks between the
wall and wall seal.
A. Apply 100% silicone sealant to the outside edge of the
threshold. Allow sealant to cure according to the
manufacturer’s instructions before using the shower.
B. Adjust the rollers to lower the door panels closer to the
shower base/bath ledge. Refer to the “Panel
Adjustment and Maintenance” section.
C. Check the height of the header. The top of the header
should be aligned with the top of the wall seals.
D. Adjust the door panel so the panel touches both the
top and boom bumpers. Try not to spray water
directly onto the door panels.
E. Install the sliding panel seal on the moving panel and
locate it between the top and boom bumpers. Make
sure the sliding panel seal aligns with the top of the
boom bumper.
F. If there is a gap between the boom of the wall seal
and the top of the threshold and boom bumpers,
silicone this area.
G. Apply 100% silicone sealant where the wall meets the
wall jamb, both inside and outside the shower. Allow
sealant to cure according to the manufacturer’s
instructions before using the shower.
6. The handle hits the
fixed panel when the
door is opened.
A. The extra top bumper was
not located correctly or
has moved.
A. Set the extra top bumper in the correct location
according to the instructions.
1460483-2-B
28 Kohler Co.