Installation Instructions

11. Prepare the Fixed Panel
Remove the corner protectors from the xed panel.
Align the top of the xed panel wall seal with the top of the wall side edge of the xed panel. Do not remove the
adhesive backing at this time.
Verify that the label on the panel will face the outside of the shower, then press the seal onto the panel.
Place the xed panel into the channel in the threshold seal and lean the top of the panel against the header.
Verify that the top of the header and the top of the xed panel are aligned.
Slide the xed panel against the wall.
Mark the xed panel hole locations onto the header.
Carefully remove the xed panel and set aside in a safe location.
Kohler Co. 15
1460483-2-B