Installation Instructions

4. Trim the Sliding Panel Wall Seal
1/2"
(13 mm)
1/2"
(13 mm)
IMPORTANT! The wall seal must be level and plumb for proper header installation.
NOTE: Do not cut away the entire seal when trimming the tabs.
Trim 1/2" (13 mm) of the tabs from the seal at the top and boom of the seal.
Insert the trimmed seal into the L-shaped channel on the sliding panel side bumper.
Using a level and masking tape, secure the seal to the wall.
Verify that the wall seal is level and plumb.
1460483-2-B
8 Kohler Co.