Installation Instructions

5. Mark and Drill the Wall Bracket Holes
IMPORTANT! The wall seal must be level and plumb for proper header installation.
IMPORTANT! The sliding panel wall seal will be used to measure the wall bracket holes on both sides of the shower.
IMPORTANT! Hole locations for the wall brackets are critical. Make sure the holes are properly marked and drilled
straight into the wall.
Position the drill template over the wall seal, pointing into the shower as shown.
Verify that the template is fully seated over the wall seal, at against the wall, and level.
Mark the hole locations and remove the template.
Drill 1/4" holes straight into the wall at the marked locations. Make sure the drill is not at an angle when drilling.
Install the provided wall anchors. Make sure the anchors are fully seated into the wall.
Repeat for the opposite wall using the same sliding panel wall seal.
Kohler Co. 9
1460483-2-B