Installation Instructions

20. Install the Top Bumper
2"
(51 mm)
Inside of Shower
8-18 x 3/8"
1/8"
NOTE: The top bumper is required for 54" (1372 mm), 66" (1676 mm), and 72" (1829 mm) door sizes. Install the top
bumper if supplied. If not supplied, proceed to the next section.
Slide the door open until the edge of the sliding panel is 2" (51 mm) from the edge of the xed panel.
From inside the shower, slide the bumper along the header until it contacts the edge of the sliding panel.
Mark the two screw hole locations.
Remove the bumper and drill a 1/8" hole at each of the marked locations. Only drill through the inside wall of the
header.
Place the bumper back on the inside of the header and secure with two 8-18 x 3/8" screws (provided).
1460483-2-B
24 Kohler Co.