Installation Instructions

3. Position the Threshold
1/4"
(6 mm)
1/4"
(6 mm)
NOTICE: The threshold must sit on a at surface.
If needed, le the ends of the threshold to match the corner radius of the shower wall.
If needed, trim the bumpers to match the corner radius of the shower wall.
Press the bumpers onto the ends of the threshold.
Align the threshold 1/4" (6 mm) from the shower base/bath ledge along the entire length and mark its location.
Tape the threshold securely in place along the mark, centered between the walls.
Press the bumpers against the walls if there is a gap.
Kohler Co. 7
1460483-2-B