Watertile Bodyspray Installation and User Guide MODEL NUMBERS 8002A $ Important! Please quote the above model number(s) when ordering spares IMPORTANT INSTALLER: THIS MANUAL IS THE PROPERTY OF THE CUSTOMER AND MUST BE RETAINED WITH THE PRODUCT FOR MAINTENANCE AND OPERATIONAL PURPOSES.
BEFORE YOU BEGIN All information is based on the latest product information available at the time of publication. Kohler Co. reserves the right to make changes in product characteristics, packaging, or availability at any time without notice. Please leave these instructions for the consumer. NOTES: 1. Flush the water supply pipes thoroughly to remove any debris. 2. An in line water filter must be used with this product. 3. Inspect the supply pipes for damage. Replace as necessary. 4.
INSTALLATION Before you Begin 1. 2. Turn off the water supply. Kohler Co. reserves the right to make revisions in the design of products without notice. Install the Supply Pipes Single Bodyspray Installation Single Bodyspray Installations 1. 2. Install the water supply pipes. Do not fix the pipework at this time. Install an elbow to the end of the supply pipe at the bodyspray installation location. Nipple Multiple Bodyspray Installations 1. 2. Install the water supply pipes.
Install the Finished Wall 1. 2. 3. 4. 5. 6. 7. Finish the wall, leaving the cutout 102 to 108 mm square. Make sure that the dimension from the front face of the elbow or tee to the surface of the finished wall is a minimum of 57 mm. Thread the nipple into the elbow or tee and hand tighten. Measure the distance from the end of the nipple to the surface of the finished wall. Make sure that it is between 38 and 44 mm. If necessary cut the nipple to the required length.
Finish the Installation 1. With the ribs of the sprayhead facing up, attach the sprayhead to the waterway. 2. Using a 3/16” hexagonal wrench, fit the sprayhead to the waterway with the two securing screws (supplied). Do not overtighten. 3. Check the sprayhead for upward and downward movement and that is sits squarely within the concealing plate. 4. Place the nozzle membrane over the sprayhead. 5. Align the long edge of the membrane with the hinge ribs (horizontal).
SPARE PARTS 1051498 Nipple G1/2 1045771** Concealing Plate 1079599 Grommet 1036043 Shield 1055233 Adapter 3007215 Screen Washer 1040636 Flow Restrictor 1044060 O-Ring 1045773 Base (Includes Clamps) 1041362 Wire 1036038 Screw 1056104 Spring Washer 1036040 Spacer 1047041 Washer 1044058 O-Ring 1040637 Screw 1044059 O-Ring A **Finish/color code must be specified when ordering.
CARE AND CLEANING Like anything of lasting quality, Kohler tapware and fittings require a certain amount of periodic care to preserve their lustrous finish. Clean your new Kohler tapware and fittings with a mild soap, rinse thoroughly with warm water and dry with a clean, soft cloth. The ideal cleaning technique is to always blot dry any water from metal surfaces. Allowing water to evaporate on metal will form water deposits.