Installation Guide

1. Install the Supply Piping
Multiple Bodyspray Installations
Route the water supply lines.
If installing more than one bodyspray off the same supply line, construct a
pressure balancing loop. Locate a tee along the loop at each bodyspray installation
location.
Do not strap the pipes at this time.
Single Bodyspray Installations
Route the water supply line.
Install an elbow to the end of the supply pipe at the bodyspray installation
location.
All Installations
Temporarily install a nipple to each tee/elbow. Do not use any sealant.
Do not strap the pipes at this time.
Installer la tuyauterie d’alimentation
Installations de jets corporels multiples
Acheminer les lignes d’alimentation d’eau.
Si plus d’un jet corporel d’une même ligne d’alimentation est installé, construire
une boucle de régulation de pression. Localiser un T le long de la boucle à chaque
emplacement d’installation de jet corporel.
Ne pas attacher les tuyaux à ce moment.
Installations d’un seul jet corporel
Acheminer la ligne d’alimentation d’eau.
Pressure Balancing Loop
Boucle de régulateur de pression
Bucle de regulación de presión
Single Bodyspray Installation
Installations d'un seul jet corporel
Instalación de un solo rociador corporal
Nipple
Mamelon
Niple
Nipple
Mamelon
Niple
Multiple Bodyspray Installation
Installations de jets corporels multiples
Instalación de múltiples rociadores corporales
Water Supply
Alimentation d'eau
Suministro de agua
1095094-2-A 4 Kohler Co.