How to Guide
Product Information
Applicable products:
6’ bath whirlpool K-865-N1
6’ bath whirlpool with neckjets and pillow K-865-H2
Fixture*:
Bathing well:
Basin area, bottom 49″ (1245 mm) x 22″ (559 mm)
Basin area, top 62″ (1575 mm) x 28″ (711 mm)
Weight 455 lbs (206.4 kg)
To overflow:
Water depth 17″ (432 mm)
Capacity 89 gal (336.9 L)
* Approximate measurements for comparison only.
Product kW V A*
Neckjets 1.5 240 15
Without neckjets 1.5 240 11
* Approximate measurements for comparison only.
Drop-in cut-out 70-1/4″ (1784 mm) x 34-1/2″ (876
mm)
Cut-out for
undermount
K-582 template for K-865-H2 only.
K-865-N1 cannot be undermounted.
Required accessories:
Jet trim kit K-9696
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual
Current Device (RCD):
Pump/control 208-240 V, 20 A, 50/60 Hz
Installation Notes
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of
69 lbs/square foot (333 kg/square meter) loading.
Cast iron whirlpools are extremely heavy, making some
drop-in installations difficult. Splitting the deck/surround is
recommended if installing into a deck.
Hot water supply should be 70% of capacity or greater.
Installations will vary.
Fixture conforms to ASME A112.19.1/CSA B45.2. All
dimensions are nominal.
K-865-N1
3/4"
(19 mm)
No change in measurements if connected with
drain illustrated. (K-7169-AF or K-7169M-AF)
Pump/Control Access
34" (864 mm) W x 15" (381 mm) H
3-1/2"
(89 mm)
18"
(457 mm)
15-5/8"
(397 mm)
2-1/2"
(64 mm)
71-3/4" (1822 mm)
36" (914 mm)
20-7/8"
(530 mm)
1/4" (6 mm)
3"
(76 mm)
2-7/8"
(73 mm)
1-1/2" OD
Roughing-In
K-865-H2,K-865-N1
TEA-FOR-TWO
®
6’ BATH WHIRLPOOL
TEA-FOR-TWO
®
6’ BATH WHIRLPOOL
1019452-1-
F