Installation Guide

1. Diverter Configurations
Configurations for Deck-Mount Installations
The small port is for the handshower (or showerhead).
The port directly across from the small port is for the bath spout.
Default flow is through this port.
The remaining two ports are for the hot and cold water inlet
supplies. They are interchangeable. If only one of these ports is
needed, cap the other port.
Configurations for Wall-Mount Installations
When diverting between the bath spout and handshower (or
showerhead):
The small port is for the handshower (or showerhead).
The port directly across from the small port is for the bath spout.
Default flow is through this port.
Cartridge
3/4"-14
NPSM
Thread
1/2"-14 NPSM
Thread
Spout 1/2" Nominal
(5/8" OD)
Handshower 3/8"
Nominal (1/2" OD)
Hot or
Cold 1/2"
Nominal
(5/8" OD)
Hot or
Cold 1/2"
Nominal
(5/8" OD)
Deck-Mount
Wall-Mount
From Mixer
Handshower or
Showerhead
Review instructions for
specific configurations.
1/2" Nominal (5/8" OD)
3/4"-14 NPSM Thread
3/8" Nominal (1/2" OD)
1/2"-14 NPSM Thread
Showerhead
or Bath Spout
Cartridge
From Mixer
113228-2-CC 4 Kohler Co.