Installation Guide

4. Install the DTV+ Interface to the Housing
NOTE: The K-99693 digital interface is required to complete this
installation.
Apply silicone sealant to the inside edges of the foam gasket near
the bottom of the housing.
Feed the interface cable through the hole in the housing.
Tilt the top of the interface onto the tabs in the housing.
Press the bottom of the interface until it clicks in place.
If the interface needs to be removed from the housing, insert a
3/32″ hex wrench to unlatch the bottom, then tilt out.
Apply
silicone
sealant.
Foam
Gasket
Install
Remove
Kohler Co. 7 1256292-2-B