Installation Guide

6. Surface-Mount – Hang the Cabinet
NOTE: The following instructions are for surface-mount only. For recess-mount installation, refer to the
″Recess-Mount″ sections.
IMPORTANT! Never leave the door supported with only one hinge attached. Get assistance supporting
the door.
Open and remove the door(s). While supporting the door, remove the screws from the bottom hinge
first.
Slide the hanger hooks onto the top T-slot.
Position each hook 2″ (51 mm) from the ends of the cabinet.
Lift the cabinet onto the mounting bar. Make sure the hanger hooks engage the bar.
2" (51 mm)
1267931-2-F 10 Kohler Co.